The main cause of lost or dripping faucet is a bad rubber washer. Sometimes the bad disk is accompanied by a bad water valve seat as well. In single handle faucets, the cause is the same, the solution is different.
The small rubber parts that consume the tap water in the seal. Occur between the stem and the valve seat broke over and over again, and as they get older, they become the most difficult terrain, as you pull the knob closer to stop. Brand new tear taps have tried this problem, solving increasingly complex root systems, but they are still dependent on rubber seals to stop water.
This article will deal with the old style, two handle faucets, and tap the two most recent management style of dance. Single treatment or lever taps are considered in a future article.
Treated older faucets use two more or less the same style of tribes, all based on the price PfisterDesign. There are differences, but the principle is the same. The knob is attached to the tree. If you turn the handle, the threaded rod moves up and down within the body of the faucet.
At the end of the stem is a rubber gasket. If to the bottom of the seal against a rubber instead of brass, ensuring a great advantage over him for a good seal. Over time the rubber becomes brittle and breaks it becomes so hard against the seat, which cuts crushed, or simplybecomes so stoned that does not seal anymore.
To fix the leak, you need the following tools:
1 screwdriver gently prying the handle of the button, which removes the screw caps.
2 To remove an adjustable wrench to the stem.
3 A tool instead of tap to the hardware store for about $ 12.00. Pick it up, if you willParties.
Turn off water by closing the angle stops under the sink. Turning off one side at a time, you will be able to determine loses, but I always just replace them both.
Once the water off, opened to bleed both sides to remove hot and cold water in the pipes longer, then the buttons. I always put the screws into the knobs and put them out of the sink.
Then, remove the stems with the adjustable wrench and turningclockwise. Make sure that the nylon washers, and save the nut on the valve body seal.
Once the stick out, you can look at the rubber seal at the end. Notice how it's all confused? Next stick your pinky in the hole was from the tribe. This is one of the seats against the rubber-rimmed closes. The upper edge of the seat should be smooth. If it is difficult or chip in it, you have to replace the seattoo.
Inspect the end of the stick. If the brass is damaged, you need to buy a new tribe. This is a newer model valve, the rubber is close to the top and locked in the trunk of the tree group and against the tire. In this case, there is no place.
In plastic taps, there are a number of different stem cells developed, but to start as soon as fall, basically you have to replace the cartridge stem cells.
In all threeCases, I suggest you make sure that the old parts with you to the hardware store to make sure the right parts.
When you return, remove the valve in reverse order. If the seats must be replaced, turning out the tool through the hole in the center and counterclockwise. For some reason, always seem to have been installed by Hercules. If you put the new one, make sure they are fixed.
AfterAssembly, remove the aerator from the faucet end of the arm. Then turn the water and check that the fall has healed. Let the water run for a minute while you clean the aerator. Reinstall the aerator after it has been cleaned.
Now you know how to fix a dripping faucet! You do not need to pay a plumber or handyman to do it for you. You have $ 80 or $ 100 or so, stored, so you should be proud of themselves. Now you can splurge on a new pair of shoes or a newFishing rod.
No comments:
Post a Comment